| |
Audmods.com
Aluminum E-Brake Handle |
Manufacturered By:
INSTALLATION DIFFICULTY: 1/5
Simple Installation - No Tools, Anyone Can Install
Easily installed, these handbrakes are the perfect way to enhance the silver, titanium or chrome parts of your cars interior. (ie: dash trim, gauge rings, aluminum pedals, shift knobs, door handle).
Machined out of aluminum, these e-brake handles are custom made for your vehicle with care and precision.
Available in a round design for all past BMW vehicles and a square base design for all newer BMWs.
All our e-brake handles are machined out of aluminum for perfect fitment. Our silver and gunmetal e-brake handles are brushed, and our beryllium handbrakes are anodized with a gloss finish.
Our chromed e-brake handle has a fully chromed body over finely machined aluminum. Our Black handles are powder coated to resist scratching and wear.
Our carbon fiber e-brake handles are made from real silver or black carbon fiber layered over machined aluminum.
The 3 bolts, instructions, the allen key and zip tie are all provided with each e-brake handle.
For a great match, make sure you check out our other products available in the same finishes by clicking below.
No permanent modifications are necessary to your vehicle to make the installation of this product possible.
NOTE: For E90, E92, E60, E63, E65, E70, E71 models: If you purchase a handbrake with a round end as opposed to a squareish end, it will still fit however, the hole in your boot is larger than our e-brake takes up. You will be required to fold over the bottom part of the e-brake boot as you install it. This can be done at the bottom so it is not visible when it is installed.
NOTE: You will be required to remove your original e-brake handle in order to install these replacements. Your original handle should slide right off once you remove the zip tie holding it in place. If you find it difficult to remove, you may need to run some lubricant (such as WD-40) down the shaft to loosen the handle. If it is still difficult to remove wiggle it back and forth as you pull up. Remember that the handle will come of this way, there is nothing else holding it on, it just may take some strength and patience.
NOTE: These e-brake handles replace only the handle itself. Your original e-brake button will remain in place. |
|
|
|
|
